1. INTRODUCTION
The security of large-scale establishments like hospitals, factories, shopping malls, and colleges is difficult to ensure when there is an absence of the fire systems. Such places have many floors, long corridors, and plenty of people. It is very difficult to assign just one guard. Efficient staffing and proper shift planning determine the actual security versus the poor one.
Properly deploying fire watch security guards across complex or expansive layouts requires a strategic approach to coverage and duty cycles. By carefully balancing patrol routes and shift rotations, facility managers can prevent fatigue and ensure continuous, vigilant oversight in every high-risk zone throughout the outage.
2. START WITH A SITE SURVEY
Determine the number of guards required by taking an overall walk through the property. Consider the size of each building, number of floors, and the risky areas. The kitchen, boiler room, storerooms, and laboratories require more attention than the offices.
Know the status of the fire systems. For example, if sprinklers are not working in just one wing of the property, then the watch will be focused there. However, if the alarm system is entirely off, then the entire facility needs to be covered.
3. DECIDE HOW MANY GUARDS ARE NEEDED
This figure will be based on the time taken to cover the whole area. If it takes a single guard forty minutes to cover each of the areas and there is a requirement to have a patrol after an hour according to the code, this guard does not get adequate time.
Bigger properties usually divide the whole area into zones. A single guard covers each zone, while a supervisor rotates between them.
4. BUILD A SHIFT SCHEDULE
The fire watch should continue throughout day and night until the system is repaired. Normally, the most common shift schedules for guards are eight hours or twelve hours. The former helps keep guards alert, while the latter allows fewer handovers.
Consider breaks. Guards must never leave any area unmanned just because another guard is taking a break. This can be covered by a relief guard.
Think about weekends and public holidays. Absence due to sickness is common. In addition, it is advisable to rotate guards from one area to another as the same routine may reduce alertness of guards.
5. KEEP HANDOVERS CLEAR
Every shift change is risky when notes are inadequate. The retiring guard should inform the succeeding guard about any dangers or maintenance problems. There should be a written record passed on from one guard to another without fail.
6. USE SUPERVISION AND COMMUNICATION
A supervisor needs to frequently visit the site to ensure that patrols are timely and record keeping is done. The guards need to be equipped with radios or telephones in order to communicate with one another and the fire department without any delay. Having a good command structure facilitates faster decision-making in emergencies. Have a daily discussion with the building’s manager about the status of the repair.
7. CONCLUSION
A fire watch in a big building needs to be planned. It is essential to carry out a full site inspection, determine how many guards are necessary, plan the rotation schedule, and ensure good changeover procedures. Following these measures, it becomes possible for a big building to stay safe and comply with fire codes till all its systems are functioning properly.







Comments